Winding bobbin, Devanado de la canilla, Preparation de la canette – SINGER 118 FEATHERWEIGHT II User Manual
Page 12: Devanado de ia caniiia, Préparation de ia canette
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

WINDING BOBBIN
1. Place a spool of thread on the spool
pin. Secure it with the spool cap to
ensure smooth flow of thread.
2. Pass thread from spool through thread
guides as shown.
3.
Puli end of thread through hole in
bobbin as shown.
4.
Push bobbin winder shaft to far left
position, if it is not already there. Place
bobbin onto shaft with end of thread
coming from top of bobbin. Push bobbin
winder shaft to right until it clicks. Hold
onto end of thread.
5. Start machine. The thread that is held
will snap or may be trimmed with a
scissor. Bobbin will cease turning when
completely filled. Push shaft to left to
remove bobbin.
l O
DEVANADO DE LA CANILLA
1.
Colocar un carrete de hilo en el
portacarretes. Asegurarlo con la tapa
portacarretes,
para
garantizar
una
salida suave del hilo.
2. Pasar el hilo desde el carrete, a través
del guía hilo, tal como está mostrado.
3. Estirar el extremo del hilo, a través del
agujero en la canilla, tal como está
mostrado.
4.
Empujar el eje del devanador canilla
hacia la posición maxima izquierda, si
no está ya ahi. Colocar la canilla en el
eje, con el extremo del hilo saliendo
por la parte superior de la canilla.
Empujar hacia la derecha el eje del
devanador, hasta que se sienta un
golpe seco. Retener el extremo del hilo.
5. Poner en maroha la máquina. El hilo
que está retenido se soltará. La canilla
cesará de girar cuando se haya llenado
por
completo.
Empujar
hacia
la
izquierda el eje para sacar la canilla.
PREPARATION DE LA
CANETTE
1. Plaçez une rouleau de fil sur le porte-
bobine. Bloquez-la avec le couvre-fil
afin d’assurer le bon déroulement du
fil.
2. Passer le fil dans le guide fil comme
illustré.
3. Introduire le fil dans un des trous de la
canette.
4.
Pousser l’axe du dévidoir vers la
gauche, placer la canette sur cet axe.
Pousser le tout vers la droite jusqu’au
déclic. Tenir le bout de fil.
5.
Mettre la machine en marche. La
canette va se remplir. Continuer à tirer
sur le bout de fil et il va se couper.
Dès que la canette est pleine, elle
s’arrêtera de tourner. Pousser la canette
vers la gauche pour pouvoir enlever la
canette.