Sears 113.22643 - Manual (Page 8)

assembly
INSTALLING SANDING DISC AND GUARb
1. Locate; sanding disc and peei backing from disc.
Align perimeter of disc with plate and press disbhrmly
into position all the way around, v
2. Locate disc guard and two pan head screws, M4.2 x
1.4'12, from loose parts bag.
3. Position disc guard against lower 1/3 of disc aligning
holes as shown.
4. Using Phillips type screwdriver, fasten the pan head
screws securely applying slight pressure to thread
the holes.
INSTALLING WORK SUPPORT
i Lbcate work support and hex screw M6 x 1.0-14,
: washer and lockwasher
2. Hold wortc support into position and fasten as shown.
: Do not overtighten.
INSTALLING TABLE ASSEMBLY
1: Locate table support and (3) hex head screws, M6 x
1.0-14, washer and lockwashersamong loose parts.
2. Position table support against table, aligning holes as
shown. .....................
3. Fasten table support to table as shown.
LOCKWASHER FLAT WASHER
HEX SCREW
. ii-n
WORK SUPPORT
HEX SCREW
WORK SUPPORT
HEX HEAD SCREW (3)
WASHER i3)
LOCKWASHER (3)