Fâiiéie::opèfâîiôn – Sears 113.22643 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

;fâiiéie::OpèfâîiÔn'

Always sand dUtside curves on the left side of center on
the sanding disc as shown.

WARNING ; Applying the workpiece to the right side
of the disc could cause workpiece to fly up {kick
back) and result in an injury.

SANDING SMALL END SURFACES ON

THE SANDING DISC

NOTE: Use of a Miter Gauge {optional accessory) is
recommended for this operation.

Always move the work across left side of center on the

sanding disc face as shown. - ; :

v ^

MITER GAUGE

WARNiNG: Applying the workpiece tothe right side

of the disc first could cause workpiece to fly up
(kickback) and result in an injury.

WARNING; For your own safety, turn switch "OFF”
and remove plug from power source outlet before
adjusting your sander.

NOTE: Use a combination square to square the miter
gauge to the face of the disc (combination square must

be True”- See "Unpacking ' Tools Needed" section on
page 6 for checking this method). It it is not square,
loosen the miter gauge knob and move the miter gauge
slightly until^ it is square. VVithout moving the miter

gauge, tighten the knob securely.

Always position the workpiece to the left of center on
sanding disc with disc rotating counterclockwise as

shown.

The table may be tilted for beveled woili.