Sears 113.22643 - Manual (Page 21)

troubleshooting
WARMING: For your own safety, turn switch “OFF”
and remove plug from power source outlet before
troubleshooting your sander.
TROUBLE PROBABLE CAUSE REMEDY
Motor will not run. 1. Defective On-Off switch
Defective switch cord.
Defective switch box.
2. Burned out motor.
1. Replace defective parts before using belt
disc sander again.
2. Consult Sears Service. Any attempt to
repair this motor may create a HAZARD
unless repair is done by a qualified
service technician. Repair service is
available at your nearest Sears Store.
Machine slows down
when sanding.
1. Timing belt too tight.
2, Applying too much pressure to
workpiece.
1. Decrease belt tension, see Maintenance
section, "Removing Pulley Cover and
installing Timing Belt."
2. Ease up on pressure.
Sanding Belt runs
off pulleys. 1. Not tracking properly. 1, Adjust tracking, see Assembly section,
“Installing the Sanding Belt - Tensioning
and Tracking”
Wood burns while
sanding. 1. Sanding disc or belt is
glazed with sap.
1. Replace disc or belt.
Excessive noise. 1, Timing beit too tight.
1. Decrease beit tension, see Maintenance
Section "Removing Pulley Cover and
Installing Timing Belt".
sears recommends the following
accessories
ITEM CAT NO.
Miter Gauge
Sanding Belts and Discs
Leg Set 9-24214
See Catalog
9-22244
Sears may recommend other accessories not listed in
the manual. See your nearest Sears store or Catalog
department for other accessories.
Do not use any accessory unless you have received and
read complete instructions for its use.
21