Sears 113.21308 - Manual (Page 4)

b. Drum Sanders must NEVER be operated on
this drill press at a speed greater than 1800
RPM.
c. Do not install or use any drill that exceeds 7" in
length or extends 6" below the chuck jaws. They
can suddenly bend outward or break.
d. Do not use wire wheels, router bits, shaper cut­
ters, circle (fly) cutters or rotary planers on this
drill press.
11. Note and Follow the Safety Warnings and In­
structions that Appear on the Panel on the
Right Side of the Head:
DANGER FOR YOUR OWN SAFETY:
О
Know This Tool! Read and Understand Owner’s Manual before Using this
Machine. Use Recommended Drill Speed- See Chart Inside Pulley Cover.
■ Always wear safety goggles that comply with ANSI Z87.1
s Do not wear gloves, necktie or loose clothing. Tie back
long hair.
a Securely clamp work to table if it is too short to contact
the column when in operating position.
" Securely lock head and support to column, and table
to support, before operating drill press.
O • Ifse only recommended accessories.
12. This Drill Press has 3 speeds as listed below:
620 RPM
1300 RPM
3100 RPM
See inside of guard for specific placement of belt
on pulleys.
13. Think Safety. Safety is a combination of operator
common sense and alertness at all times when the
drill press is being used.
WARNING: DO NOT ALLOW FAMILIARITY (GAINED
FROM FREQUENT USE OF YOUR DRILL PRESS)
TO BECOME COMMONPLACE. ALWAYS RE­
MEMBER THAT A CARELESS FRACTION OF A
SECOND
IS SUFFICIENT TO INFLICT SEVERE
INJURY.
The operation of any power tool can result in foreign
objects being thrown into the eyes, which can result in
severe eye damage. Always wear safety goggles com­
ply with ANSI Z87.1 (shown on Package) before com­
mencing power tool operation. Safety Goggles are
available at Sears retail or catalog stores.