Sears 113.21308 User Manual
Crrftsmrn, Sêmm, Owner’s
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Save This Manual
For Future Reference
SÊMm
owner’s
manual
MODEL NO.
113.213080
DRILL PRESS WITH
MAXIMUM DEVELOPED
1/3 HP MOTOR
Serial
Number ______________________
Model and serial number
may be found at the rear of
the head.
You should record both
model and serial number in
a safe place for future use.
CAUTION
READ ALL
INSTRUCTIONS
CAREFULLY
CRRFTSMRN
MOTORIZED
8-INCH
BENCH MODEL DRILL PRESS
• assembly
• operating
• repair parts
Sold by SEARS, ROEBUCK AND CO., Chicago, IL 60684 U.S.A.
Part No.
SP5184
Printed in Taiwan
Table of contents
Document Outline
- Save This Manual For Future Reference
- MODEL NO.
- 113.213080
- • assembly
- • operating
- • repair parts
- Part No. SP5184
- Printed in Taiwan
- GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS
- 1. KNOW YOUR POWER TOOL
- 2. GROUND ALL TOOLS
- 3. KEEP GUARDS IN PLACE
- 4. REMOVE ADJUSTING KEYS AND WRENCHES
- 5. KEEP WORK AREA CLEAN
- 6. AVOID DANGEROUS ENVIRONMENT
- 7. KEEP CHILDREN AWAY
- 8. MAKE WORKSHOP CHILD-PROOF
- 9. DON’T FORCE TOOL
- 10. USE RIGHT TOOL
- 11. WEAR PROPER APPAREL
- 12. USE SAFETY GOGGLES (HEAD PROTECTION) Wear safety goggles (must comply with ANSI
- 13. SECURE WORK
- 14. DON’T OVERREACH
- 15. MAINTAIN TOOLS WITH CARE
- 16. DISCONNECT TOOLS
- 17. AVOID ACCIDENTAL STARTING
- 18. USE RECOMMENDED ACCESSORIES
- 19. NEVER STAND ON TOOL OR ITS STAND
- 20. CHECK DAMAGED PARTS
- 21. DIRECTION OF FEED
- additional safety instructions for drill presses
- motor specifications and eiectrical requirements
- unpacking and checking contents
- location and function of controls
- assembly
- TOOLS NEEDED
- ASSEMBLY OF BASE/COLUMN
- INSTALLATION OF TABLE/SUPPORT ASSEMBLY AND HARDWARE
- INSTALLING THE HEAD
- INSTALLING FEED HANDLES
- basic drill press operation
- WARNING: FOR YOUR OWN SAFETY, ALWAYS OBSERVE THE SAFETY PRECAUTIONS HERE AND ON PAGES 2, 3, AND 4.
- 1. Protection: Eyes, Hands, Face, Ears and Body
- WARNING: TO AVOID BEING PULLED INTO THE SPINNING TOOL -
- 1. Do NOT wear:
- — loose clothing
- — jewelry
- 2. Do tie back long hair
- INSTALLING DRILLS
- POSITIONING TABLE AND WORKPIECE
- TILTING TABLE
- HOLE LOCATION
- FEEDING
- adjustments
- maintenance
- lubrication
- SERVICE
- MODEL NO. 113.213080
- 8-INCH
- BENCH MODEL DRILL PRESS