Sears 113.21308 - Manual (Page 22)

maintenance
WARNING FOR YOUR OWN SAFETY, TURN
SWITCH “OFF" AND REMOVE PLUG FROM POWER
SOURCE OUTLET BEFORE MAINTAINING OR LUB­
RICATING YOUR DRILL PRESS.
Frequently blow out any dust that may accumulate in­
side the motor.
A coat of furniture-type paste wax applied to the table
and column will help to keep the surfaces clean.
WARNING: TO AVOID SHOCK OR FIRE HAZARD,
IF THE POWER CORD IS WORN OR CUT, OR DAM­
AGED IN ANY WAY, HAVE IT REPLACED IM­
MEDIATELY.
SPINDLE ASSEMBLY
OF DRILL PRESS
lubrication
All of the BALL BEARINGS are packed with grease at
the factory. They require no further lubrication.
Periodically lubricate the SPLINES (grooves) in the
spindle, and the RACK (teeth of the quill).
SPLINES
(GROOVES)
SPINDLE
RACK
(TEETH)
CHUCK
Sears Recommends the Following Accessories
Drill Bits ............................................ See Catalog
Hold-Down and Guide ................................ 9-2457
Drill Press Vises.................................... See Catalog
5 pc. Stop Collar Set.............................. See Catalog
Sanding Drums............................ 9-2497 — 9-2498
15 Piece Drum Sanding Kit .................... See Catalog
Clamping Kit.......................................See Catalog
Buffing Wheels up to 4” dia. max..............See Catalog
Power Tool Know-How Handbook................... 9-29117
Sears may recommend other accessories not listed in
the manual.
See your nearest Sears store or Catalog department
for other accessories.
Do not use any accessory unless you have received and
read complete instructions for its use.
22