Installing the head – Sears 113.21308 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TABLE

3. Locate support lock handle among loose parts.

4. Install support lock handle from left side into table

support. Raise table to working height by sliding it
on the column and then tighten lock handle by
hand.

TABLE

INSTALLING THE HEAD

CAUTION: The head assembly weighs about 45
pounds. Carefully lift head.

1. Remove protective covering from head.

2. Carefully lift head above column tube and slide it

down on the column as far as it will go. Align head
with table and base.

COLUMN

HEAD LOCK

SET SCREWS

3. Using a 4mm Hex “L” wrench tighten the head lock

set screws on the right side of the head.