beautypg.com

Sears 113.21308 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

This Drill Press has 3 speeds as listed below:

620 RPM

1300 RPM

3100 RPM

See inside of belt guard for specific placement of belts
on pulleys.

SPINDLE

SPEEDS

IN R-P.M.

1

. BELT GUARD ... Covers pulleys and belt during

operation of drill press.

2.

BELT TENSION LOCK HANDLE . . . Tightening

handle locks motor bracket support to maintain cor­
rect belt distance and tension.

3.

HEAD LOCK SET SCREWS . . . Locks the head

to the column. ALWAYS have them locked in place
while operating the drill press.

4.

TABLE SUPPORT ... Rides on column to support

table.

5. COLUMN

SUPPORT . . . Supports column and

provides mounting holes for column to base.

6.

SUPPORT LOCK HANDLE . . . Tightening locks

table support to column. Always have it locked in

place while operating the Drill Press.

7.

BASE .. . Supports Drill Press. For additional sta­

bility, holes are provided in base to bolt Drill Press
to bench (See “Additional Safety Instructions for

Drill Presses.”)

8.

SPRING CAP . . . Provides means to adjust quill 20.
spring tension.

9.

depth

pointer

... Indicates drilling depth and

is located between stop nuts.

10.

DEPTH SCALE . . . Shows depth of hole being

drilled in inches and millimeters.

11

. COLUMN ... Connects head, table, and base on

a one-piece tube for easy alignment and move­
ment.

12.

BEVEL SCALE . . . Shows degree table is tilted

for bevel operations. Scale is mounted on table

support. It if to be used for quick reference where
accuracy is not critical.

TABLE

BEVEL LOCK . . . Locks the table in any

position from 0°-45°.
TABLE . . . Provides working surface to suoport
workpiece.

FEED

HANDLE . . . For moving the chuck up or

down. One or two of the handles may be removed

if necessary whenever the workpiece is of such
unusual shape that it interferes with the handles.

CHUCK . .. Holds drill bit or other recommended
accessory to perform desired operations.

FEED

STOP ROD . . . Holds stop nuts for drilling

to specific depths.

STOP NUTS . .. Limits the downward movement
of the quill at any desired point within its travel,
and prevents the pointer from moving upward.

“ON-OFF SWITCH .. . Has locking feature. THIS
FEATURE IS INTENDED TO PREVENT UNAU­
THORIZED AND POSSIBLE HAZARDOUS USE

BY CHILDREN AND OTHERS.

CHUCK KEY . . . It is a self-ejecting chuck key
which will “pop” out of the chuck when you let go
of it. This action is designed to help prevent throw­

ing of the chuck key from the chuck when power
is turned “ON”. Do not use any other key as a
substitute, order a new one if damaged or lost.

BELT TENSION . . . Refer to section “Tensioning
Belt” (Page 13).
DRILLING SPEED ... Can be changed by placing
the belt in any of the STEPS (grooves) in the pul­

leys. See Spindle Speed chart inside belt guard.

To determine the approximate drilling speed, refer to
the table inside the belt guard.

13.

14.

15.

16

17,

18

19

21

.

22

16