Flexcap flc coping, Print approval, Material – Flex FLC Coping User Manual
Page 4: Quantities
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
APPROVH
FLEXCAP FLC COPING
EXISTING SLOPE WITH NAILER VERSION
ANSI/SPRI ES-1 TESTED
L
Coping is to be installed per Specifications and Flex's Installation Instruction Dwg. # 28111-3460
- Concealed splice plates are provided with factory applied dual
non- curing sealant strips.
- Unless otherwise noted, fabrication of miters and accessories
are furnished standard utilizing a non-penetrating quicklock joint,
then factory sealed watertight.
Fabrication will proceed only after receipt of
signed print approval.
Print Approval:
Architect and/or contractor shall verify all
dimensions, sizes and quantities. All
products to be installed in strict accordance
with Flex's printed instructions.
Approved by:
Date:
_____
■ Welded Miters and Accessories
Check one □ Required (surcharge) □ Not applicable
MATERIAL:
__24 Ga. (0.65 mm) Galv.
_ .040" (1.01 mm) Alum. Color:.
_ .050" (1.27 mm) Alum.
__.063" (1.60 mm) Alum. Finish:
OTHER________________
QUANTITIES:
___ Lineal Feet 12'-0" (3.65 m) Lengths
Outside Miters @ (_______°)
Inside Miters @ (______ °)
Right End Caps
Left End Caps
PROJECT:
ARCHITECT:
ROOFING CONTRACTOR:
REPRESENTATIVE/DISTRIBUTOR:
Customer Service:
Phone: 800-969-0108
Fax:610-916-9501
DATE: 12/13/10
DRN BY: JJC
CKD BY: SAK
SHT.# OF
DWG# 28011-3459
c
print approvai
74
p: 800-969-0108
f: 610-916-9501