Print approval, Quantities, 7" coping miters – Flex FLC Coping User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
*7" COPING MITERS
OUTSIDE
FACE
OUTSIDE FACE HEIGHT
OUTSIDE
OUTSIDE FACE HEIGHT
FACE
R.H. QUANTITY,
□ STANDARD LEG LENGTHS
□ CUSTOM LEG LENGTHS _
LH. QUANTITY.____________
□ STANDARD LEG LENGTHS
□ CUSTOM LEG LENGTHS _
NOTES:
- Concealed splice plates are provided with factory
applied dual non-curing sealant strips.
“ Unless otherwise noted, fabrication of miters and accessories are
furnished standard utilizing a non-penetrating quicklock joint, then
factory sealed watertight.
Fabrication will proceed only after receipt of
signed print approval.
Print Approval:
Architect and/or contractor shall verify all
dimensions, sizes and quantities. All
products to be installed in strict accordance
with Flex's printed instructions.
Approved by:
Date:
_____
- Welded Miters and Accessories
Check one □ Required (surcharge) □ Not applicable
MATERIAL:
__ 24 Ga. (.65 mm) Steel
__ .040" (1.01 mm) Alum.
Color:
__ .050" (1.27 mm) Alum.
__ .063" (1.60 mm) Alum.
Finish:
Other
QUANTITIES:
Right Hand Miter(s) @
(_
Left Hand Miter(s) @
PROJECT:
ARCHITECT:
ROOFING CONTRACTOR;
REPRESENTATIVE/DISTRIBUTOR:
Customer Service:
Phone: 800-^969-0108
Fax:610-916-9501
DATE: 12/13/10
DRN BY: JJC
CKD BY: SAK
SHTJ OF
DWG# 28011-3476
print approval
90
p: 800-969-0108
f: 610-916-9501