Non 90° angle for coping, Roof, Side – Flex FLC Coping User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NON 90° ANGLE FOR COPING
MEASUREMENT WORKSHEET FOR USE WITHOUT A PROTRACTOR
ROOF
SIDE
PLACE MARK HERE
PLACE MARK HERE
WALL
SIZE
ROOF
SIDE
WALL
SIZE
1. CIRCLE APPROPRIATE "ROOF SIDE" TO INDICATE OUTSIDE MITER OR INSIDE MITER.
2. STARTING AT EITHER SIDE OF THE CORNER, MEASURE ALONG THE WALL EDGE A CONVENIENT
DIMENSION, SUCH AS 24" OR 36", DEPENDING ON JOB SITE CONDITIONS. PLACE A MARK ON
THE WALL AND RECORD MEASURED DIMENSION AS "DIM A" IN THE DRAWING ABOVE, REPEAT
PROCEDURE FOR THE OPPOSITE WALL, AS SHOWN ABOVE.
3. MEASURE STRAIGHT ACROSS FROM MARK TO MARK, AS SHOWN, AND RECORD THE MEASURED
DIMENSION AS "DIM B".
4. IF ORDERING COPING, PLEASE RECORD THE WALL SIZES WHERE INDICATED. FAX THIS SHEET
TO 610-916-9501 WITH ORDER.
PROJECT:
Customer Service:
Phone: 800-969-0108
Fax:610-916-9501
ARCHITECT:
ROOFING CONTRACTOR:
REPRESENTATIVE/DISTRIBUTOR:
DATE: 12/13/10
DRN BY- JJC
SHT.# OF
CKD BY: SAK
DWG# 28811-3470 C
detail
84
p: 800-969-0108
f: 610-916-9501