Flex FLC Coping - Manual (Page 2)

APPROVE)
FLEXCAP FLC COPING
TAPERED VERSION
ANSI/SPRI ES-1 TESTED
Coping cover 12'-0'
(3.65 m) lengths
8" (203 mm) wide
concealed splice plate at
each joint
12" (305 mm) wide
20 ga. (1 mm) galvanized
anchor clips 4'-0" (1.22 m) o.c.
'A'
NOANa-M^ll \Vm)
Cwsty,
'C
Inside Face
Min. 2 1/4" (57 mm)
Max. 6" (152 mm)
3/8" (10 mm)
space provided for
wall variations
Outside Face
Min. 3" (76 mm)
Max. 6" (152 mm)
Actual wall width
Coping is to be installed per Specifications and Flex's Installation Instruction Dwg. # 28111-3454
- Concealed splice plates are provided with factory applied dual
non- curing sealant strips.
“ Unless otherwise noted, fabrication of miters and accessories
are furnished standard utilizing a non-penetrating quicklock Joint,
then factory sealed watertight.
Fabrication will proceed only after receipt of
signed print approval.
Print Approval:
Architect and/or contractor shall verify all
dimensions, sizes and quantities. All
products to be installed in strict accordance
with Flex's printed instructions.
Approved by: _____________________________
Date: _____________________
■ Welded Miters and Accessories
Check one □ Required (surcharge) □ Not applicable
MATERIAL:
Color:
24 Ga. (0.65 mm) Galv.
. .040" (1.01 mm) Alum.
.050" (1.27 mm) Alum.
. .063" (1.60 mm) Alum. Finish:
OTHER________________
QUANTITIES:
__ Lineal Feet (12'-0" (3.65 m) Lengths)
Outside Miters @ (_______ °)
Inside Miters @ (______ °)
Right End Caps
Left End Caps
PROJECT:
ARCHITECT:
ROOFING CONTRACTOR:
REPRESENTATIVE/DISTRIBUTOR:
Customer Service:
Phone: 800^969-0108
Fax:610-916-9501
DATE: 12/13/10
DRN BY: JJC
CKD BY: SAK
SHT.# OF
DWG# 28011-3169
print approval
72
p: 800-969-0108
f: 610-916-9501