Flex FLC Coping - Manual (Page 28)

FLEXCAP FLC WELDED RADIUS COPING
FLAT VERSION
IMPORTANT!!!
MUST INDICATE PROPER RADIUS CONDITION BY
CIRCLING APPROPRIATE OUTSIDE FACE
PROVIDING A RADIUS
THE RADIUS MAY BE PROVIDED
IN ONE OF TWO METHODS:
1.) THE ACTUAL KNOWN RADIUS IS
ROOF LINE
OR
2.) FIELD CONDITION MEASUREMENTS
NOTE: REFER TO ATTACHED WORKSHEET
OUTSIDE
FACE
RADIUS
(PROVIDED BY APPROVER
PER DETAIL A)
TOP
VIEW
15/16“
(24
mm) I
15 / 16 “
(24 mm)
(457 mm)
MIDPOINT OF
STRAIGHT EDGE
INSIDE
FACE
MIN. 2 1/4" (57 mm)
MAX. 6" (152 mm)
(914 mm)
LENGTH OF
STRAIGHT EDGE
NOTE: CHECK MEASUREMENTS ALONG ENTIRE RADIUS.
DETAIL A
OUTSIDE
FACE
MIN. 3“ (76 mm)
MAX. 6“ (152 mm)
3/^"(10mm) SPACE
PROVIDED FOR
WALL VARIATION
MOTF^* “ Concealed splice plates are provided with factory
” applied dual non-curing sealant strips.
Fabrication will proceed only after receipt of
signed print approval.
Print Approval:
Architect and/or contractor shall verify all
dimensions, sizes and quantities. All
products to be installed in strict accordance
with Flex's printed instructions.
Approved by:
Date: _____
MATERiALS:
Top - .080" (2.03 mm) Alum.
Sides - .063" (1.60 mm) Alum.
Color:_________________________
Finish:________________________
QUANTITiES:
Lineal Feet 4'-0" (1.22 m) Lengths
PROJECT:
ARCHITECT:
ROOFING CONTRACTOR:
REPRESENTATIVE/DISTRIBUTOR:
Customer Service:
Phone: 800-969-0108
Fax:610-916-9501
DATE: 12/13/10
DRN BY: JJC
CKD BY: SAK
SHT.# OF
DWG# 28011-11385 B
print approval
98
p: 800-969-0108
f: 610-916-9501