Flex FLC Coping User Manual

Flexcap flc coping

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Flexcap FLC Coping

Tapered, Flat and Existing Slope with Nailer Versions

Warranty:

The entire roof

system

is covered under one warranty and inspected after the project is complete to

assure proper installation. The system is inspected after the project is complete to assure proper

installation. This ensures protection for the most vulnerable area of the roof against failure due to

extreme wind up lift pressures.

Testing:

• Tested per ANSI/SPRI ES-1 Standard to comply with the International Building Code.

“ Factory Mutual 1-90 approved for wind up lift protection.

• Miami-Dade Approved (No. 08-0604.02 12/11/13) to comply with the “High Velocity Hurricane

Zone of the Florida Building Code”.

Available Materials:

Its unique design allows for covers to be manufactured in 24 ga. steel, .040", .050" and .063"

aluminum.

Watertight:

Its 8" wide concealed splice plates with dual non-curling isocryl butyl sealant strips allow for thermal

movement of materials and provides a watertight seal at all joints.

Competitively Priced:

The installed cost rivals even light gauge roof edge systems fabricated locally or in a roofer’s shop.

Efficient Design:

A fuU, snap-on design in 12'-0" lengths and no crimping make for quick installation and low labor

costs. Pre-punched fastening holes ensure proper attachment to the building substrate. Corrosion

resistant, stainless steel springs are factory attached to the anchor clips and provide long-term,

positive spring loading. No adhesives are required.

Colors:

Choose among a wide range of standard colors and finishes that meet your job requirements. A 20

year Kynar 500® finish warranty is included on standard colors. Custom post-coated Kynar 500

colors are available with an included 10 year Kynar 500 finish warranty or a 20 year Kynar 500 finish

warranty is available upon request. Anodized finishes are also available, but are not warranted.

Custom Capabilities:

Radius and specially fabricated products are available to meet the unique needs of each project.

Accessories:

Factory fabricated miters provide a cleaner, more aesthetically pleasing appearance. This eliminates

the need for field fabrication, providing time and labor savings.

Also Included:

All fasteners are included and will arrive to the job site with the product.

p: 800-969-0108

f: 610-916-9501

features & benefits

Table of contents