Non 90° coping miters, Print approval, Customer service – Flex FLC Coping User Manual
Page 15: Phone:800-969-0108, Fax:610-916-9501
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NON 90° COPING MITERS
OUTSIDE MITER-OBTUSE
□ Standard Leg Lengths
□ Custom Leg Lengths
OUTSIDE MITER
ACUTE
Qty.
INSIDE MITER-OBTUSE
□ Standard Leg Lengths
□ Custom Leg Lengths _
Qty.
- Unless otherwise noted, fabrication of miters and
accessories are furnished standard utilizing a non
penetrating quicklock joint, then factory sealed watertight.
— Welded Miters and Accessories
Check one □ Required (surcharge) □ Not applicable
MATERIALS:
__ 24 Ga. (.65 mm) Steel
__ .040" (1.01 mm) Alum.
__ .050" (1.27 mm) Alum.
Color:
__ .063" (1.60 mm) Alum.
Other
Finish:
□ Tapered □ Flat
NOTES:
-- Concealed splice plates are provided with factory
applied dual non-curing sealant strips.
Fabrication will proceed only after receipt of
signed print approval.
Print Approval:
Architect and/or contractor shall verify all
dimensions, sizes and quantities. All
products to be installed in strict accordance
with Flex's printed instructions.
Approved by:
Date:
_____
PROJECT:
ARCHITECT:
ROOFING CONTRACTOR:
REPRESENTATIVE/DISTRIBUTOR:
Customer Service:
Phone:800-969-0108
Fax:610-916-9501
DATE: 12/13/10
DRN BY: JJC
CKD BY: SAK
SHT.# OF
DWG# 28011-3471
c
p: 800-969-0108
f: 610-916-9501
print approval
85