Carrier 26H - Manual (Page 22)

26H S E R V I C E
Carrier
FIG. 3 - ICE CRUSHER ASSEMBLED - FRONT VIEW
CRUSHER OPERATION
The defrost and freezing cycles of an Ice Maker
with a crusher are identical to those of units without
a crusher. Normally the crusher is a factory mount­
ed accessory, enclosed in the machine section. If
desired, a crusher package may be purchased sep­
arately for installation. (See Fig. 3)
CAUTION; When cleaning units equipped with
crushers or performing service operations, discon­
nect the power supply.
The two crusher control knobs are mounted on the
lower front panel (Fig. 4). When the knob on the
left is positioned on "Crushed" the cubes pass
through the crusher and crushed ice falls into the
bin. Fineness of the crushed ice is controlled by
the knob on the right. When the knob on the left
is positioned on "Cubes", the ice cubes bypass
the crusher and fall into the bin.
The knob marked "Crushed - Cubes" controls a
switch to the crusher motor and the position of a
damper to direct the cubes. The motor is cut out of
the control circuit when the switch is turned to
"Cubes".
When ice builds up in the bin and touches the ther­
mostat bulb, the unit will stop. If the crusher knob
is in the "Crushed" position and the bin thermostat
stops the unit during the harvest cycle^ the crusher
me tor will continue to operate until the main control
switches to the freezing position or the selector
switch is turned to "Pump" or "Off". This prevents
accumulation of cubes at the crusher entrance.
#
FIG. 4 - ICE CRUSHER CONTROLS
26H-57PD
22