Carrier 26H - Manual (Page 14)

26H
INSTALLATION
Carrier
14. INSTALL BIN THERMOSTAT BULB
Remove the tope holding the bin thermostat cap­
illary and bulb in a coiled position inside the right
side of the machine section. Uncoil 4 or 5 loops
of the capillary and insert the bulb through the hole
in the right rear corner of the machine section into
the bin. Run the capillary along the top of the bin
and down the back of the thermostat bulb bracket.
See Figs. 12 and 13.
SIDE View DETAIL
FIG. 12 - BIN THERMOSTAT CAPILLARY AND
BULB ARRANGEMENT
26H 5-500. 240 AND 160 LB. BINS
BIN
THERMOST^r
a HI PRESS.
CUTOUT
OR BIN
tms S ostat
ARY
FIG. 13 RIGHT SIDE OF 26H3 SECTION -
PANELS REMOVED
Instructions for mounting the thermostat capillary
and bulb on a partition are included in the partition
package.
CAUTION: Insulate the capillary where it goes
through the hole in the machine section and the
bin with tape or rubber tubing.
15. INSTALL CRUSHER GUARD
Remove crusher guard assembly from ice chute on
grusher models and install per instructions in para­
graph 19 on page 39.
Attach the clamp to the bottom hole in the bracket;
insert the thermostat bulb in the clamp so it ex­
tends 1/2" below the bottom of the bracket. Tighten
the clamp.
26H3-100 LB. BINS
With the clamp attached to the bracket at the top
hole in the arm of the bracket, insert the thermo­
stat bulb in the clamp so the clamp is approximately
in the middle of the bulb and tighten the clamp.
16. INSTALL SIPHON STANDPIPE AND
ADJUST FLOAT
Remove the ice deflector to gain access to the water
pan. Fig. 14.
Place standpipe assembly and rubber grommet in
water pan drain. (See Fig. 14). On 26H3 unit,
remove knockout in stainless steel jacket. (Do
not remove on 26H5 unit.)
t
26H-57PD 14