Cisco 3560 - Manual (Page 75)

3-19
Catalyst 3560 Switch Hardware Installation Guide
OL-6337-07
Chapter 3 Switch Installation (8- and 12-Port Switches)
Installing the Switch
Securing the AC Power Cord
The AC power-cord retainer is an optional part (PWR-CLIP-CMP).
Step 1 Insert the power-cord retainer wire into the slot on the plastic holder.
Step 2 Attach the plastic holder onto the switch rear panel with the supplied screw (see Figure 3-11 ).
Figure 3-11 Insert the Power-Cord Retainer
Step 3 Rotate the wire to the right side of the AC power cord connector, and insert the AC power cord (see
Figure 3-12 ).
Figure 3-12 Insert the AC Power Cord
Step 4 Place the power cord bushing on the power cord with the opening at the top. The retainer wire only fits
into one slot on the bushing. Move the retainer wire into the bushing slot (see
Figure 3-13 ).
Figure 3-13 Attach the Power-Cord Bushing
Step 5 Slide the bushing so that it rests against the power-cord connector, and then rotate the bushing clockwise
until the bushing is securely fastened and its opening is on the right side of the power cord (see
Figure 3-14 ).
250519
250520
250521