Cisco 3560 User Manual
Page 110
D-2
Catalyst 3560 Switch Hardware Installation Guide
OL-6337-07
Appendix D Configuring the Switch with the CLI-Based Setup Program
Preparing for Setup
Step 2
Use the supplied RJ-45-to-DB-9 adapter cable to insert the RJ-45 connector into the console port on the
switch rear panel, as shown in
Figure D-2
Connecting a Switch to a PC
Step 3
Attach the DB-9 female DTE of the adapter cable to a PC serial port, or attach an appropriate adapter to
the terminal.
Step 4
Wait before you power on the switch.
Step 5
Before you power on the switch, start the terminal emulation session to see the output from the power-on
self-test (POST). The terminal-emulation software—frequently a PC application such as Hyperterminal
or ProcommPlus—makes communication between the switch and your PC or terminal possible.
Step 6
Configure the baud rate and character format of the PC or terminal to match these console port default
characteristics:
•
9600 baud
•
8 data bits
•
1 stop bit
•
No parity
•
None (flow control)
Step 7
Connect one end of the supplied AC power cord to the power connector on a switch rear panel. See
Step 8
Connect the other end of the power cable to a grounded AC outlet.
1
Catalyst 3560 switch
3
RJ-45-to-DB-9 adapter cable
2
Power cord
RATING
100-200V ~
5.0A-2.5A, 50-60 HZ
CONSOLE
DC INPUTS FOR REMO
TE
POWER SUPPL
Y
SPECIFIED IN MANU
AL
+12v @7.5A -48 @7.8A
2
3
97934
1