Cisco 3560 - Manual (Page 44)

2-12
Catalyst 3560 Switch Hardware Installation Guide
OL-6337-07
Chapter 2 Switch Installation (24- and 48-Port Switches)
Installing the Switch
Wall-Mounting
These switches wall-mount only with the front panel facing up:
• Catalyst 3560-24PS, 3560-24TS-S, 3560-48PS, and 3560-48TS-S
• Catalyst 3560G-24PS, 3560G-24TS, 3560G-48PS, and 3560G-48TS
These switches wall-mount with the front panel facing up or down:
• Catalyst 3560V2-24PS, 3560V2-24TS, 3560V2-48PS, and 3560V2-48TS
The illustrations in this section show the Catalyst 3560G-48PS switch as an example.
Caution You must install the RPS connector cover before wall-mounting the switch.
Warning Read the wall-mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system. Statement 378
To install the switch on a wall, follow the instructions in these procedures:
• Attaching the Brackets to the Switch for Wall Mounting, page 2-12
• Attaching the RPS Connector Cover, page 2-13
• Mounting the Switch on a Wall, page 2-14
Attaching the Brackets to the Switch for Wall Mounting
Figure 2-10 shows how to attach a 19-inch bracket to one side of the switch. Follow the same steps to
attach the second bracket to the opposite side.
Figure 2-10 Attaching the 19-inch Brackets for Wall Mounting
1 Phillips truss-head screws
40 41 42 43 44 45 46 47 48
47X
48X
97925
Catalyst 3560
SERIES PoE-48
1
2
3
4
1