Triner Scale TMU-295 - Manual (Page 72)

5-32 Commands
Bit 1: • Becomes On (slip printing possible) when slip paper is detected
and becomes Off (slip printing is not possible) when slip
ejection starts or time-out.
• When the printer goes to the slip wait status, bit 5 and 6 of the
third byte are On (no paper) and bit 1 of the forth byte is On
(slip printing is not possible).
• When paper-end stop is disabled by ESC c 4, bit 1 does not
become On (slip printing is not possible) even if no printing
area remains.
• When the release button is pressed during slip printing, bit 1
becomes On (slip printing is not possible).
[Default] n = 0
[Reference] DLE EOT , ESC u, ESC v
GS r n
[Name] Transmit status
[Format] ASCII GS r n
Hex 1D 72 n
Decimal 29 114 n
[Range] 1
≤
n
≤
2, 49
≤
n
≤
50
[Description] Transmits the status specified by n as, follows:
[Notes] • When DTR/DSR control is selected, the printer transmits only 1
byte after confirming the host is ready to receive data (DSR signal
is SPACE). If the host computer is not ready to receive data (DSR
signal is MARK), the printer waits until the host is ready. When
XON/XOFF control is selected, the printer transmits only 1 byte
without confirming the condition of the DSR signal.
• This command is executed when the data in the receive buffer is
developed. Therefore, there may be a time lag between receiving
this command and transmitting the status, depending on the
receive buffer status.
6
Off 00 0 Undefined.
On 40 64 Undefined.
7 Off 00 0 Not used. Fixed to Off.
n Function
1, 49 Transmits paper sensor status (same as ESC v)
2, 50 Transmits drawer kick-out connector status (same as ESC u 0)
Bit Off/On Hex Decimal Status for ASB