Triner Scale TMU-295 - Manual (Page 43)

Commands 5-3
[Description] Prints the data in the print buffer and returns to standard mode.
[Notes]
• The buffer data is deleted after being printed.
• The printer does not execute paper ejection.
• This command sets the print position to the beginning of the line.
[Reference] ESC L
CR
[Name] Print and carriage return
[Format] ASCII CR
Hex 0D
Decimal 13
[Description] When auto-line feed is enabled, this command functions in the same
way as LF. When auto-line feed is disabled, this command is ignored.
[Notes] • This command sets the print position to the beginning of the line.
• This command is available only with a parallel interface and is
ignored with a serial interface.
DLE EOT n
[Name] Real-time status transmission
[Format] ASCII DLE EOT n
Hex 10 04 n
Decimal 16 4 n
[Range] 1 ≤ n ≤ 3, n = 5
[Description] Transmits the selected printer status specified by n in real time,
according to the following parameters:
n = 1: Transmit printer status
n = 2: Transmit off-line status
n = 3: Transmit error status
n = 5: Transmit slip paper status
[Notes] • The printer executes this command upon receiving it.
• When transmitting status, the printer transmits only 1 byte
without confirming the condition of the DSR signal.
• With the serial interface model, this command is executed even in
off-line or receive buffer-full state. However, with the parallel
interface model, this command is not executed in off-line or
receive buffer-full state because the printer is busy and unable to
receive this command from the host.
• The status is transmitted whenever the data sequence of
<10>H<04>H (1 ≤ n ≤ 3, n = 5) is received even if it appears as
part of another command. For example,
In ESC ✻ m n L n H [d] n L+256 ✕ n H, d1=<10>H, d2=<04>H,
d3=<1>H