Triner Scale TMU-295 - Manual (Page 25)

1-14 Installation
3. While holding down the RELEASE button, turn the printer back
on.
4. Remove your finger from the RELEASE button. The printer
prints the current printer settings and then eject the paper.
5. Press the RELEASE button to eject the paper completely and
insert new paper to begin the second part of the test.
After the printer prints a pattern, it prints the following message:
***completed***
The printer ejects the paper; then enters the normal mode.
Setting the DIP Switches
You can change several interface settings by changing the DIP
switch settings. If you need to change any of these settings, follow
the steps below:
1. Make sure that the printer is off.