Commands 5-29 – Triner Scale TMU-295 User Manual
Page 69
Commands 5-29
[Notes]
• If n = 0, ASB is disabled.
• ASB is enabled if only one status is selected. The printer
automatically transmits a status of four bytes whenever the status
changes.
• If ASB is enabled while processing this command, the current
status is transmitted with no regulations.
• When transmitting a status, the printer transmits only four bytes
without confirming the condition of the DSR signal.
• Four bytes of status data must be consecutive, except for XOFF
code.
• This command is executed when the data in the receive buffer is
developed. Therefore, there may be a time lag between receiving
this command and transmitting the status, depending on the
receive buffer status.
• When the printer is disabled by ESC =, this command is disabled
but ASB is not disabled.
• When using ESC u, ESC v, GS I or DLE EOT, the status
transmitted by this command, the ASB information, and the status
transmitted by another commands must be differentiated.
• The status to be transmitted are as follows:
1
Off
00
0
On-line/Off-line status disabled.
On
02
2
On-line/Off-line status enabled.
2
Off
00
0
Error status disabled.
On
04
4
Error status enabled.
3
Off
00
0
Undefined.
On
08
8
Undefined.
4
Off
00
0
Undefined.
On
10
16
Undefined.
5
Off
00
0
Slip sensor status disabled.
On
20
32
Slip sensor status enabled.
6
Off
00
0
Undefined.
On
40
64
Undefined.
7
Off
00
0
Undefined.
On
80
128
Undefined.
Bit
Off/On
Hex
Decimal
Status for ASB