Mounting the switch on a wall – Cisco 3750 User Manual
Page 31

2-13
Catalyst 3750 Metro Switch Hardware Installation Guide
OL-9160-02
Chapter 2 Switch Installation
Installing the Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure that the switch is attached securely to wall studs
or to a firmly attached plywood mounting backboard. Mount the switch with the front panel facing up,
as shown in
Warning
To comply with safety regulations, mount switches on a wall with the front panel facing up.
Statement 266
Warning
Suitable for mounting on or over concrete or other non-combustible surface only. Statement 345
Figure 2-11
Mounting the Switch on a Wall
After the switch is mounted on the wall, perform these tasks to complete the installation, to run the setup
program, and to access the switch:
•
Connect to the console port, and start the emulation software. See the
and the
“Starting the Terminal-Emulation Software” section on page C-3
.
•
Power on the switch. See the
“Connecting to a Power Source” section on page C-4
1
User-supplied screws
97438
SY
ST
RP
S
MA
ST
R
ST
AT
DU
PL
X
SP
EE
D
ST
AC
K
MO
DE
1
1