Mounting the switch in a rack, Figure 2-8 mounting the switch in a rack – Cisco 3750 User Manual
Page 29
2-11
Catalyst 3750 Metro Switch Hardware Installation Guide
OL-9160-02
Chapter 2 Switch Installation
Installing the Switch
Mounting the Switch in a Rack
After the brackets are attached to the switch, use the four supplied number-12 Phillips machine screws
to securely attach the brackets to the rack, as shown in
Figure 2-8
Mounting the Switch in a Rack
After the switch is mounted in the rack, perform these tasks to complete the installation, run the setup
program, and access the switch:
•
Connect to the console port, and start the emulation software. See the
and the
“Starting the Terminal-Emulation Software” section on page C-3
.
•
Power on the switch. See the
“Connecting to a Power Source” section on page C-4
•
Run the setup program. See the
“Completing the Setup Program” section on page C-5
•
Connect to the front-panel ports. See the
“Connecting to the 10/100 Ports” section on page 2-17
and
the
“Connecting to an SFP Module” section on page 2-18
to complete the installation.
To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal
program or through the network by using Telnet. For configuration information, refer to the switch
software configuration guide or the switch command reference.
1
Phillips machine screws
PWR A
SYST
PWR B
MASTR
STAT
DUPLX
SPEED
STACK
MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
1X
2X
11X
12X
13X
14X
23X
24X
1
2
3
4
CONSOLE
97435
1
Catalyst 3750 Metro
series
ES PORTS