Toa HY-VM7W - Manual (Page 7)

7
Step 3. Attach the angle bracket of this bracket to the T-bracket.
Use four of the supplied bolts to secure.
Step 4. Mount the HY-VM7’s T-bracket and angle bracket, and Bracket B of the HY-C0801 or HY-C0801W to
the speaker.
Subsequent procedures are the same as those described in Steps 2 to 4 in the chapter, "MOUNTING
THE SPEAKER ON A WALL" (p. 3 and 4). However, read "HY-WM7B or HY-WM7W" as "HY-
C0801 or HY-C0801W."
Step 5. Fit the HY-C0801’s or HY- C0801W’s Bracket B bolt into the notch of Bracket A.
In this event, a fixed washer must be positioned above the notch, and a plain washer positioned below
it.
Angle bracket
T-bracket
Hex head bolt M6 x 20 with spring
and plain washers (accessory)
Tightening torque: 8 N·m
Owing to the speaker’s size and weight, be sure that at least two
persons are available to install the unit. Failure to do so could
result in personal injury.
WArNINg
Safety bolt
This bracket (T-bracket)
This bracket (Angle bracket)
HY-C0801 or HY-C0801W
(Bracket A)
Nut for M8
Plain washer for M8
Fixed nut
Horizontal angle
adjustment nut
Plain washer
HY-C0801 or HY-C0801W
(Bracket B)
5
7
8
6
HX-7B or HX-7W
Tightening torque:
8 N·m
Step 6. Insert the safety bolt into Bracket A of the
HY-C0801 or HY-C0801W, and tighten the
bolt securely with a nut.
Step 7. Adjust the speaker’s horizontal angle.
After completing adjustment, tighten Bracket
B’s horizontal angle adjustment nut.
Horizontal angle adjustment range:
180° to left and right (360° for entire circumference)
Step 8. Set the angle bracket’s angle and secure with a bolt.
Subsequent procedures are the same as those described in Step 10 in the chapter, "MOUNTING THE
SPEAKER ON A WALL" (p. 5).
Step 9. Mount the safety wires.
For the safety wire mounting method, refer to the operating instructions supplied with the HX-7B or
HX-7W speaker.