Toa HY-AH1 - Manual

Please follow the instructions in this manual to obtain the optimum results from this unit.
We also recommend that you keep this manual handy for future reference.
HY-AH1 ANCHOR HANGING BRACKET
INSTRUCTION MANUAL
Indicates a potentially hazardous situation which, if mishandled, could
result in death or serious personal injury.
WARNING
Indicates a potentially hazardous situation which, if mishandled, could
result in moderate or minor personal injury, and/or property damage.
CAUTION
1. SAFETY PRECAUTIONS
• Be sure to read the instructions in this section carefully before use.
• Make sure to observe the instructions in this manual as the conventions of safety symbols and messages
regarded as very important precautions are included.
• We also recommend you keep this instruction manual handy for future reference.
• Leave the installation to your TOA dealer because the installation requires expert knowledge. Improper
installation may cause the speaker to fall, resulting in personal injury and/or property damage.
• Install the mounting hardware in a location that can structurally support the weight of the mounting hardware
and the speaker. Doing otherwise may result in the speaker falling down and causing personal injury and/or
property damage.
• Do not use other methods than specified to mount the unit. Extreme force is applied to the unit and the unit
could fall off, possibly resulting in personal injuries.
• Tighten each nut and bolt securely. Ensure that the unit has no loose joints after installation to prevent
accidents that could result in personal injury.
• Use the specified speaker in combination. Doing otherwise may cause the speaker or component to fall off,
resulting in personal injury.
• Avoid touching the unit's sharp metal edge to prevent injury.
2. GENERAL DESCRIPTION
TOA's HY-AH1 Anchor Hanging Bracket is designed to be mounted to an anchor bolt to prevent the full weight
of a flush-mounted ceiling speaker from being directly applied to the ceiling panel. The ceiling reinforcement
ring which is supplied with the speaker is required when using the Anchor Hanging Bracket.
3. SPECIFICATIONS
Finish Steel plate, plating
Weight 700 g
Usable Speaker F-122C, F-2322C, F-2352C, F-2852C
Note: The design and specifications are subject to change without notice for improvement.
• Accessory
Paper pattern ................................... 1