Toa HY-0871CL - Manual

Please follow the instructions in this manual to obtain the optimum results from this unit.
We also recommend that you keep this manual handy for future reference.
HY-0871CL SPEAKER MOUNTING BRACKET
INSTRUCTION MANUAL
SAFETY PRECAUTIONS
• Be sure to read the instructions in this section carefully
before use.
• Make sure to observe the instructions in this manual as
the conventions of safety symbols and messages
regarded as very important precautions are included.
• We also recommend you keep this instruction manual
handy for future reference.
Safety Symbol and Message Conventions
Safety symbols and messages described below are used
in this manual to prevent bodily injury and property
damage which could result from mishandling. Before
operating your product, read this manual first so you are
thoroughly aware of the potential safety hazards as well as
understand the safety symbols and messages.
• Install the unit only in a location that can structurally
support the weight of the unit and the mounting bracket.
Doing otherwise may result in the speaker falling down
and causing personal injury and/or property damage.
• Owing to the speaker's size and weight, be sure that at
least two persons are available to install the speaker.
Failure to do so could result in personal injury.
• Use nuts and bolts (not supplied with the unit) that are
appropriate for the ceiling's or wall's structure and
composition. If the ceiling or wall cannot withstand the
weight of both the speaker and bracket, the speaker may
fall, resulting in material damage and possible personal
injury.
• When mounting the speaker to a wall, ensure that the
entrance of the bracket's temporary-fixing slot is facing
upward. If not installed facing up, the speaker may fall
off, resulting in personal injury.
• Tighten each nut and bolt securely. Ensure that the HY-
0871CL has no loose joints after installation to prevent
accidents that could result in personal injury.
• Do not hang down from the bracket, as the speaker
system and bracket could fall, resulting in personal injury.
GENERAL DESCRIPTION
The HY-0871CL Speaker Mounting Bracket is specially
designed for mounting TOA's ES-0871 Speaker System to
a wall or ceiling.
NOMENCLATURE
INSTALLATION
1. Mount both Brackets L and R to a ceiling or wall using
four bolts for each bracket.
WARNING
Angle adjustment
slot C
Angle adjustment slot B
Angle adjustment slot A
Bracket R Bracket L
Temporary-
fixing slot
Indicates a potentially hazardous
situation which, if mishandled, could
result in death or serious personal
injury.
Ceiling or wall mounting dimension (Unit: mm)
• When installing brackets as shown in Figure 1
742
819
898
190 300 357
592
672
748
357 300 190
Figure 1
Figure 2
• When installing brackets as shown in Figure 2
2. Out of four screws located on each of the speaker's top
and bottom panels, remove the following three (six in
total) from each panel.
Do not remove this screw.
(This nut is not used.)
Nut A (one each on top
and bottom panels)
Nut B (one each on top
and bottom panels)
Nut C (one each on top
and bottom panels)