Tii FDH1 User Manual
Page 13
13
Tii Network Technologies Inc. 2012
9.9. Typical PON
9.9.1. Install each MDU home run drop cable to rear patch panel, label as required.
9.9.2. Top most adapter plate for feeder cable high power pass-through and splitter connections.
9.9.3. Splice feeder fiber(s), field terminate or install stub as required rear side of top adapter plate.
9.9.4. Install splitter housing to rear panel using alignment stud and Velcro.
9.9.5. Route splitter legs to front side patch panel.
9.9.6. Install splitter input (blue strand) to top adapter plate feeder cable.
9.9.7. Install splitter outputs (yellow strands) to parking lot.
9.9.8. Activate MDU connections by moving from parking lot to dwelling ports as required.
See also other documents in the category Tii Equipment:
- OF025PFNOPNST1 (2 pages)
- IF025PFNOPNST1 (2 pages)
- 210 (2 pages)
- 220 (1 page)
- 231-2 (1 page)
- 68T-2S-4 (1 page)
- 68M-2-1T (1 page)
- 68M-12-1T (1 page)
- 68M-1-1T (1 page)
- 170-06-03 (2 pages)
- 69T (1 page)
- ISB (2 pages)
- ISB-MB (1 page)
- 372S-12LP (1 page)
- 372S-12 (1 page)
- 80-100 (1 page)
- 80-400 (1 page)
- 80-410V-45 (1 page)
- SCT-A (1 page)
- 87 (1 page)
- 95S Series (2 pages)
- 95S Series (3 pages)
- 96-00-1 SERIES (2 pages)
- 96-00-4 SERIES (2 pages)
- 97 (2 pages)
- 97C (1 page)
- 99S SERIES (2 pages)
- 831E (1 page)
- 831W2 (1 page)
- 856E (1 page)
- VIS-4 (2 pages)
- ONT-SS (1 page)
- VIS-2 (2 pages)
- FDT1 Series (2 pages)
- FDT2 Series (2 pages)
- 169F SERIES (2 pages)
- 506F (2 pages)
- 506F-03 (2 pages)
- 506F-02-01-04 (2 pages)
- 506F-01-01-01/-02/-03 (2 pages)
- UVS-12 (1 page)
- 761-4T-12 (2 pages)
- VIS-3 (2 pages)
- FET1 Series (2 pages)