ThermoWorks 9882 PRINTING DATALOGGER THERMOMETER - Manual (Page 43)

MEAS MEM LOG SET
Welcome
9851/ 9651 Hygro-Thermometer Calibration Procedure
EXIT LXW EDIT SAVE
View Cali Data
Long press
EXIT LXW MANUAL
RH Cali Mode Select
INPUT
Zcal : -7340019 E-4
Scal : 5399497 E-5
RH 32.8 %
EXIT Cali PRN
Temp:
REC
RH
WBT
DP
60.8% 17.4C
20.0C
Temp:25.5C
Input probe cali data
Press F2
Calibrate manually
Press F3
ABORT LXW ENTER SAVE
Input Cali Data
RH Manual Calibration
RH 60.8%
RH Manual Calibration
RH 75.3 %
RH Manual Calibration
ABORT
Remarks:
1. Be sure to keep a calibration
note enclosed in the package
This's for future RH probe cali-
bration use
2. While keyin the calibration value,
3. Press ABORT anytime to exit without save or press END to
save and exit if you don't want to wait for 30 minutes.
4. The LCD value will flash while doing manual 33% and 75%
calibration until the procedure finished.
5. Suggest to calibrate at stable room temp. environment.
Flashing for 30 mins
Flashing for 30 mins
No need to use
salt bottles
Need to use
salt bottles
(Need to plug probe into salt bottles)
41
Note:
"Input cali.data" method is for RH
probe replacement.
"Manual calibration" method is for
RH probe replacement & old probe
re-calibration.
Zcal : E-4
Scal : 5399497 E-5
-7340019
EXIT 75.3 32.8
(Put probe into corresponding salt bottles
for 30 mins before press F2 or F3)
END
ABORT END END
refer to the value indicated on
the note. The values are slope and offset value of each probes.
Temp. 23.5 C
Temp. 23.5 C
Temp. 23.5 C