ThermoWorks 292-601 BLUETHERM DUO WITH BLUETHERM PRO FOR iOS Quick Start Guide - Manual

BlueTherm ® Pro Quick Start Guide
HOW TO GET STARTED
1. Download the BlueTherm Pro App
2. Enable bluetooth and sync your BlueTherm using the serial number on the back
3. Enter the PIN 1234 to complete sync
4. BlueTherm Pro will automatically start monitoring and recording with default settings when connected
5. Change your display update rate, recording interval, min/max settings, and switch between C˚/F˚ in the “Settings”
tab
6. Change or add high/low and sequence alarms in the “Alarm” tab
7. Change sensor names in the “Home” tab
8. Save Profile by going to the “Profiles” tab and select “Save current settings”. Saved Profiles can be accessed later
to update all setting with one button.
HOW TO VIEW READINGS
Temperature readings can be viewed under the “Table” or “Graph” tabs. These will update with the recording intervals
set earlier. Sequence alarms will be displayed on the graph with a pin.
HOW TO VIEW SAVED READINGS
Previously recorded data can be accessed by going to the “Table” tab and selecting “Saved Data.” Select the data
session you’d like to review. You can switch between reviewing the table or graph by selecting the “Table/Graph”
button to the right of “Email Data.”
HOW TO EMAIL RESULTS
The prompt to email recorded data is found under the “Table” tab. Select the “Email Data” button and saved data
sessions will be listed. Select which session you would like to email, and enter your recipients email address. A CSV
file will be created and automatically sent.