Chapter 5 - swath width presets, Selecting swath preset – TeeJet 844-AB Sprayer Control User Manual
Page 16
14
www.teejet.com
844-AB
CHAPTER 5 - SWATH WIDTH PRESETS
The 844-AB can be programmed with up to 6 swath widths. This
allows the operator to easily change from one swath to another
during application. (This is essential when spraying orchards that
have varying swath widths.)
To enter Swath width presets mode, press and hold the GREEN
button for 3 seconds. The swath width setting screen for preset
number 1 will be displayed. The swath width is displayed on the
lower right of the console (measured in metres for SI [metric] units).
Figure 48: Entering swath width presets
1
2 3
4 5
6 7
8 9
10 11
12
11.0
Use the Plus and Minus keys to adjust the value for the first
swath preset. Press the GREEN button or the Programme key
to advance to the next swath preset. Use the Plus and Minus
keys to adjust the swath value. Continue this process through the six
possible presets. If all six presets are not required, enter values only
for the necessary number of presets. All others should be set to “0”.
Values set to “0” will not be available for selection. Once the presets
have been entered, press the GREEN button or the Programme
key to return to the Operations mode.
Figure 49: Entering swath width
1
2 3
4 5
6 7
8 9
10 11
12
13.0
Selecting swath preset
Once the swath widths are programmed, select the swath width to
be used by pressing the GREEN button during Operations mode.
The console will display which swath preset is being used. If the
preset displayed is correct, press the Programme key to return to
Operations mode.
Figure 50: Swath width selection
11.0
1
2 3
4 5
6 7
8 9
10 11
12
Should a different swath preset be desired, press the GREEN button
again to advance to the next swath selection. Continue to press the
GREEN button until the appropriate swath preset is displayed. Press
the Programme key to select the preset and return to Operations
mode.
NOTE: When toggling through swath width selections, only those
with presets programmed will be displayed (if presents
5 and 6 are set to “0”, they will not be displayed).