SUUNTO SPYDER User Manual
Page 64
62
4. While the alarm status [On/OFF] is selected (blinking), press or
to change
the status. When the alarm status is On, the depth alarm indicator ( symbol)
in the bottom right corner of the display indicates that the alarm is on.
5. While the depth digits are selected (blinking), press
to increase the value or
to decrease it at intervals of 0.5 m [1 ft]. Holding down either button starts
the scrolling of the depth value. The range of the depth is from 3.0 to 96.0 m
[10 to 315 ft].
6. After you have set the depth alarm, press the
button to save the settings
and to return to the Setting Mode [SET] (Fig. 5.2).
5.4 ALTITUDE ADJUSTMENT AND PERSONAL
ADJUSTMENT SETTING
The current Altitude and Personal Adjustment Modes are shown when diving as
well as at the surface. If the mode does not match the altitude or conditions (see
Section 4.5.), it is imperative that the diver enters the correct selection before
diving. Use the Altitude Adjustment to select the correct altitude mode. Use the
Personal Adjustment to add an extra level of conservatism.
NOTE: NEW ALTITUDE AND PERSONAL ADJUSTMENT SELECTIONS
CANNOT BE MADE UNTIL 10 MINUTES AFTER THE DIVE.
To set the new Altitude and Personal Adjustments:
1. In the Setting Mode [SET], press
four (4) times to select the Dive Adjust-
ment Mode (Fig. 5.10).