SIG SAUER SSG 3000 User Manual
Page 53
www.sigsauer.com
53
5. With the slot facing downwards, insert barrel 450 into the
receiver. Align slot with the slot in the receiver.
6. Place insert 308 into the receiver from below.
7. Lightly tighten clamping screw 306a and remove the
magazine (see section 5.7.1).
8. Insert the magazine adapter into the magazine well until it
contacts the barrel.
9. Retain magazine adapter with screw 656.
10. Check correct barrel location by lightly rotating the barrel
in both directions.
Note:
• On both sides there should be about the same gap
between the magazine adapter and the magazine well.
11. Check that the screw 656 is well seated. If necessary,
tighten it.
12. Tighten the clamping screws 306/306a and install the
stock (see section 9.2).
13. Cock the bolt (see section 5.6.1), insert (see section
5.6.3) and then lock it.
14. Cycle the bolt to check that its action is smooth.
15. Insert the magazine 658 until it snaps in.
16. Sight in the Rifle (zeroing).
Figure 21
Figure 22
302
656
657
658
14SIG1027_OM-SSG3000-USA_MiniManual_PeaseREV05.indd 53
3/27/14 11:17 AM