SIG SAUER SSG 3000 - Manual (Page 50)

50 www.sigsauer.com
9.2 Installing the stock
CAUTION! Gun may be damaged
• The spanner must not be extended by attaching a tube.
• If a torque spanner is used to tighten the stock retention screws, apply 44 lbs-in / 5 Nm.
1. Lightly turn the rear stock retention screw 514 by hand.
2. Lightly turn the rear stock retention screw 512 by hand.
3. Tighten rear stock retention screw 514.
4. Tighten front stock retention screw 512. Note:
• Correct torque for the stock retention screws is achieved
by grasping the end of the spanner and applying enough
twist to raise the Rifle into the vertical position.
519 511 512
Figure 16
14SIG1027_OM-SSG3000-USA_MiniManual_PeaseREV05.indd 50 3/27/14 11:17 AM