Reznor EFMA Unit Installation Manual User Manual
Page 25

25
120V current will produce virtually no heat. It is therefore very important to
connect the right product to the right voltage.
Q.13: Can EFMA be installed over concrete?
A.13: Yes. Apply a concrete sealer before installing the EFMA system. See Section 4.
Q.14: Can carpet be installed over EFMA?
A.14: Yes, if the system is completely embedded in self-levelling cement. You can
install low-pile carpet over the slab if the carpet’s thermal resistance does not
exceed R = 1.40 (RSI = 0.246).
Q.15: Can wood flooring be installed over EFMA?
A.15: Yes, you can install multilayer wood flooring (Engineered flooring), provided
its thermal resistance does not exceed R = 1.40 (RSI = 0.246).
Q.16: Is the use of self-levelling cement mandatory when installing ceramic tile?
A.16: If the room is small, an experienced tiler can do a good job without using self-
levelling cement, but this method is not recommended. The heating cable must
always be completely embedded in cement or an equivalent binder (cement
glue, ceramic glue, self-levelling cement). If the room is medium-sized or
large, the use of self-levelling cement is strongly recommended to ensure the
ceramic is perfectly levelled.