Reznor EFMA Unit Installation Manual - Manual (Page 22)

22
Final view
self-levelling
cement
cement glue
floor covering
4.7 Connecting the System
IMPORTANT!
The system must be connected by a master electrician.
Cold lead
- 240V/208V connection:
- 120V connection:
Line 1–Black Line–Black
Line 2–Red Neutral–White
Bare wire–ground Bare wire–ground
Measure the cable’s electrical resistance and record the readings on line 5)
Upon installing the thermostat of the measures’ table.
4.8 Measuring Resistance and Measures’ table
• The master electrician who installed and connected the EFMA system must
complete the measures’ table (this label is available at the opening of the product)
and give it to the customer. This sheet must be kept near the electrical service.
IMPORTANT!
If this table is not duly completed, the warranty may be annulled. Warranty terms are
set out in Section 8.