Reznor EFMA Unit Installation Manual - Manual (Page 20)

20
4.5 Installing the Temperature Sensor
Hot glue gun, hammer, wood chisel or concrete chisel
channel
temperature
sensor
Fig. 4.5
• To minimize floor height, chisel a 10 mm X 10 mm X 250 mm ( 3 /
8
” X 3 /
8
” X 10”)
channel in the subfloor to receive the temperature sensor.
CAUTION!
The sensor must be embedded in cement or an equivalent binder (cement glue,
ceramic glue, self-levelling cement).
• Glue the sensor to the subfloor (Fig. 4.5). The sensor must be solidly fastened to
the subfloor to ensure it stays in place when the cement or an equivalent binder
(cement glue, ceramic glue, self-levelling cement) is applied.