beautypg.com

Reznor VCT Unit Installation Manual User Manual

Page 37

background image

37

4.3 Burner Removal


Step 1: Isolate power and gas supplies.

Step 2: Disconnect the external power/control
connections.

Step 3: Detach the gas supply as shown
below, taking care to support the burner
connection.


Step 4: If ducted air is connected, loosen hose
clip and remove the flexible hose from the
burner.

Step 5: Loosen the set screw on the burner
support casting to enable the burner to be
removed from the radiant tube.

Step 6: Remove the burner and position the
burner in a safe area to prevent the burner or
components attached to the burner from falling
to the ground.


4.4 Burner Gas Injector Servicing

Step 1: Remove the 4 retaining screws, then
remove the burner support casting and gasket.

Step 2: The burner head assembly can be
disconnected by separating the connectors of
the ignition lead assembly and removing the
earth lead and pressure switch silicon tube.

This manual is related to the following products: