Reznor VCT Unit Installation Manual - Manual (Page 36)

36
Small Flat
Head
Screwdriver
4. Servicing Instructions.
These appliances should be serviced annually by a competent person to ensure safe
and efficient operation. In mildly dusty or polluted conditions more frequent servicing
may be required. Servicing work should be carried out by a qualified mechanical contractor.
Soft
Brush
Phillips
Screwdriver Leather
Faced
Gloves
½”
Wrench
4.1 Tools Required.
The following tools and equipment are advisable
to complete the tasks laid out in this manual.
Suitable alternative tools may be used.
Large Adjustable
wrenches for fitting
of Gas Flex.
5/32”
(4mm)
Allen
Wrench
Manometer Multimeter
B E D C
F
G
I
J
L
M
N
H
A
4.2 Burner Description.
Figure 19. Burner breakdown
K
O
I
Q
F
G
P
A Ignition Controller
B Gas Valve
C Power On Red LED
D Low fire Yellow LED
E High fire Yellow LED (VCT ONLY)
F Burner Tube
G Pepper Pot Head
H Injector
I Igniter Assembly
J Jet Carrier
K Combustion Fan
L Pressure Switch
M Gaskets
N Transformer
O 24v Relay (VCT ONLY)
P Burner Orifice Plate
Q Flame Plate (not shown)
Note: Cables Omitted
For Clarity
Square section
not on VCS models