Rev-A-Shelf 4WCTM-RM-2150DM-2 - Manual (Page 4)

Step 6
Re-engage the unit into each of the cabinet members being sure that the slides are
aligned properly. Once engaged fully close and open the unit a few times to ensure
proper slide operation.
Step 7
Re-install the gas spring being sure that the gas reservoir is attached to the top stud
as shown in Figure 7A. Make sure to install both of the retainer clips into each of the
stud caps.
Step 8
Attach the telescopic foot to the lower stud mount using the #8-32 X 1/2” machine
screws and flat washers provided (do not fully tighten). The stud mount is threaded so
there is no need to use a nut and the foot itself is slotted. Once you are sure the foot
is in full contact with the floor of the cabinet, tighten the machine screws. Now that
the foot is the correct length attach it to the floor of the cabinet using (2) #8 x 5/8 deep
thread screws provided. Make sure the foot and stud mount are perpendicular to the
floor of the cabinet and do not lean left or right (this will cause interference with the
gas spring that operates the waste container). (SEE FIGURE 8A)
Step 9
Attach door to unit. (SEE ENCLOSED DOOR MOUNTING INSTRUCTION SHEET)
FIGURE 7A
FIGURE 8A
12400 Earl Jones Way • Louisville, KY 40299
800-626-1126
www.rev-a-shelf.com
I-WCTMSC-0115
Step 10 Test Function
Once the door has been properly attached test the function of the unit. During the first 5-10 cycles extend the frame to the
fully open and fully closed positions assisting the entire length of travel. At this point the unit should open/close itself for
the last 6-8” of travel.
NOTE: If the unit is not opening/closing fully or not operating smoothly check the following:
-Make sure that the installation of the front and rear brackets allows for the slides to be “square” without binding by mea-
suring corner to corner on the slides with the unit in the open position .
-Check that the slides are both level front to back and that they are also level from one slide to the next (laying a level
across both slides when waste container is in the open position).
-Check that the bottom foot is vertical front to back and left to right.