Rev-A-Shelf 4-NW-MAT-XXX - Manual

THESE 2 OUTER HOLES TOWARDS
BACK OF MAT
CENTER OF MAT
CENTER HOLE
DO NOT CUT OUTSIDE
OF THIS DIAMETER!
INSTALLATION FOR KIDNEY TRAY MATS
Determine your application and then follow the steps listed.
BEARING MOUNTED
KIDNEY TRAYS
1. No trimming is necessary.
Simply place mat on tray.
POST MOUNTED
KIDNEY TRAYS
1. Place mat on tray.
2. Use “Center Cut Template”.
3. Install hub hardware.
1. Place mat on tray and locate 1” hole by applying pressure to the center of the tray.
2. Using a sharp knife cut the 1” hole in the mat.
3. Cut the profile from the template provided and remove the 1” center hole from template.
4. Align 1” hole from template and orient according to diagram.
5. Use paper template to locate the (3) holes and use an awl or screwdriver to punch holes in the mat.
6. The hub can be installed to the tray, the mat should be pinched between the tray and the top hub.
CENTER CUT
TEMPLATE:
I-M
AT
-KID
12400 EARL JONES WAY • LOUISVILLE, KY 40299 • (800) 626-1126