Rev-A-Shelf 6260-XXX User Manual
Rev-A-Shelf For Home
1. Mark center line of cabinet.
2. Place template on center line of cabinet
and butt edge of template against back of cabinet.
(arrow pointing towards back).
3. Mark and drill mounting holes,
using 1/8 diameter drill or equivalent.
4. Repeat for upper mounting bracket.
16
22
CUT HERE FOR 18”, 20”
CUT HERE FOR 16”
CABINET CENTER LINE
CABINET
TEMPLATE
1” HOLE THROUGH
BOTTOM CABINET FLOOR
ONLY FOR JACK SCREW ASSEMBLY
DRILL ONLY FOR INSTALLING
UPPER PANTRY TOP PIVOT
Note: Locations given provides proper clearance from back of cabinet.
12400 Earl Jones Way
Louisville, KY 40299
(800) 626-1126
www.rev-a-shelf.com
T-6260-TRI
Cut template
according to tray size
20
18
See also other documents in the category Rev-A-Shelf For Home:
- 445-VCG20-8 (2 pages)
- 448-VC20-8 (2 pages)
- VIB-20CR (2 pages)
- COSK-18 (2 pages)
- 432 Series (2 pages)
- 4WH-RM-15DM-1 (2 pages)
- HPRV-1520 S (2 pages)
- HURV-1512 S (2 pages)
- 4VHTM-1520DM-1 (2 pages)
- SBVDT-2124-S-1 (8 pages)
- 6882-31-15-570 (4 pages)
- 4WLS882-32-570 (1 page)
- CAG-081642-1 (2 pages)
- CBSR-Series (4 pages)
- BRC-Series (2 pages)
- CWTBR-Series (2 pages)
- CWSBR-Series (2 pages)
- CJD-2414-R (2 pages)
- CVJD-Series (2 pages)
- 5190-15RM-117 (2 pages)
- CH-241419-RM-217 (2 pages)
- CTOHB-Series (1 page)
- CM-1448-ORB-1 (2 pages)
- PSC-Series (8 pages)
- CPDR-Series (2 pages)
- CLSZ-M5-96-1 (2 pages)
- CSPD-6 (1 page)
- SHR-3684 (1 page)
- TRC-Series (2 pages)
- CWTTR-Series (2 pages)
- CWSTR-Series (2 pages)
- 6273-20-XXX (2 pages)
- 4WLS273-20-536 (2 pages)
- I-WOOD 11-05 (2 pages)
- 6072-Series (2 pages)
- 3073-Series (2 pages)
- LD-4BW-472-XXX (2 pages)
- 5472-28 CR (1 page)
- LD-2942-28-15-1 (4 pages)
- 6942-Series (2 pages)
- 4-WLS-MAT-XXX (1 page)
- 4-NW-MAT-XXX (1 page)
- 4KCB-Series (1 page)
- 4WTCD-Series (2 pages)