Rev-A-Shelf SHR-3684 - Manual

24
09
Pl
an
tsi
de
Dr
ive
•J
eff
ers
on
tow
n,
KY
40
29
9
80
0-
62
6-
11
26
•5
02
-4
91
-2
21
5f
ax
ww
w.
rev
-a-
sh
elf
.co
m
Opening
S T E P 2 S T E P 3 S T E P 4 S T E P 5
Unit… mm/inches
M
in
.5
70
m
m
/
22
.4
5"
M
in
.5
80
m
m
/
22
.8
3"
Min. 580mm/
22.83"
M
in
.1
21
9m
m
/
48
"
Min. 1219mm/
48"
Top Dimension/Bottom Dimension
S T E P 1
S tep 1.
Mount the lower tube(1) and tube(2) with
the connecter bolt(7), mount the plastic rings(5) to
two extremities of the spiral hanger(3) center pole,
mount the holder(6) and plastic rings(5) to the upper
tube(4) then attach the bearing kit.
S tep 2.
Screw the holder(6) to the tube(2) and
properly height mount the lower spiral hanger(3) and
plastic rings(5) to the tube(2) then attach the bearing
kit. Place the plastic bolt(9) in to the top of spiral
hanger(3).
S tep 3.
Mount the upper spiral hanger(3) to the
tube(2) and connect the two spiral hanger(3) together
with the plastic bolt(9) then mount the upper tube(4) to
the upper spiral hanger(3).
S tep 4.
According to the bottom dimension,
mount the complete set to the cabinet then mount the
plastic shroud into the exposed ends of the spiral
hanger(3).
S tep 5.
Adjust the holder(6) to the tube (2) at the
proper height and tighten the set screw on the holder(6)
to the tube(2) with the 6-sided wrench(11).
S piral C lothes Hanger
I-SHR1207
S HR -3684