beautypg.com

Rev-A-Shelf LD-4NW-882-38-1 User Manual

Step 4, Step 5 step 6

background image

Installation Instructions

for 38" Half Moon Lazy Susan

Attach slides to support frame starting
with the hole location noted "31" (see
illustrations. NOTE: Place end noted
"this end away from cabinet opening"
AWAY from cabinet opening. This will
ensure proper function and alignment
with other hole location.

I-4WLS38HM

Position and tape template on
inside of the face frame vertically
(hinge side) as show in illustration.
Using a 1/16" diameter bit, drill 5/8"
deep pilot holes through the
template at the 7 arrow locations.
NOTE: Be careful not to drill through
the front of the cabinet frame.

Match positioner base over 4 base holes as shown and install to cabinet
bottom using four (4) #8 x 3/4" oval head wood screws. Match support
bracket over 3 remaining pilot holes as shown and install to cabinet frame
using three (3) #8 x 3/4" oval head wood screws. Now match the other
positioner base over the 4 support bracket holes and fasten to bracket
from underneath using four (4) #10 x 1/2" machine screws. Make sure
to position lock down screw on positioner base assembly toward
cabinet opening. NOTE FOR BLIND LEFT CABINETS: Support bracket
installs as shown in illustration 2b.

Attach trays to slides per indicated holes. Cover unused holes with provided caps.

STEP 4

Take your pivot & slide assembly, match it
over the bottom positioner base and insert
the shaft through the top positioner base
until the shaft bottom (open end) sets on
cabinet bottom. Now tighten the set screws
on both positioner bases (arrow points out
top set screw). Be sure to tighten bottom
positioner base set screw (not visible).

Now slide the pivot & slide assembly
on shaft so it rests on the top postioner
base. Your installation is now complete
and should look like the illustration.

STEP 5

STEP 6

illustration 2b

31

31

CABINET OPENING SHOWN IS "BLIND RIGHT".
FOR "BLIND LEFT" APPLICATION, ROTATE
THE SLIDES (ONLY) 180

∞. USE THE SAME

HOLES IN THE SLIDES WITH THE OTHER
SET OF FOUR HOLES IN THE TRAY.

ALIGN HOLES
AS INDICATED.

31

31

18"

MIN CLR

22"

MIN CLR.

39-1/2" MIN

CLR.

BLIND RIGHT HOLE LOCATIONS NOTED IN RED

BLIND LEFT NOTED IN BLACK

12400 Earl Jones Way • Louisville, KY 40299

(800) 626-1126 • rev-a-shelf.com

This manual is related to the following products: