Rev-A-Shelf SBDT-Series - Manual (Page 2)

Sink/Vanity Base applications
New Construction (No plumbing present)
1) Measure the inside width and depth
of your base cabinet.
Note: When measuring the depth, make
sure to include the face frame thickness.
2) To trim your Drip Tray, only a utility
knife and straight edge is required. Begin by
scoring the cut line several times and simply
break on the score line. You can also do this
using a powered saw, but is not necessary.
3) Since the Drip Tray fits over the face frame and in
most cases a center mullion, you will need to trim Drip
Tray to fit flush to the front. A utility knife may be used
to make the cuts, but a power tool (jig saw, scroll saw,
etc) might give you a little more control.
4) Once tray is fitted inside
cabinet, use silicon adhesive
around the entire perimeter
and any holes you made for
plumbing. Take care to seal
all the cuts to ensure a water
tight seal.