PRG Best Boy Wash User Manual - Manual (Page 78)

70 BEST BOY ® WASH LUMINAIRE USER MANUAL
CAUTION: Do not touch gobos with bare fingers. Wear cotton gloves or finger cots when handling.
Step 5. Rotate Gobo Wheel so that desired gobo is accessible (Figure 4-12).
Step 6. Rotate gobo to align magnet with alignment mark on sun gear.
Step 7. Using hook & pick tool, carefully pull out retaining ring and remove gobo.
Figure 4-12: Replacing a Gobo
Step 8. Install new gobo by aligning its magnet with alignment mark on sun gear (as shown in Figure 4-12) and then
inserting into place.
Step 9. Replace retaining ring.
Step 10. When finished, rotate gobo wheel as a visual test. When properly installed, the gobo magnet for each
installed gobo should be positioned in the same approximate position as the gobo wheel is spun around.
Adjust as necessary.
Step 11. Replace Head Cover.
Gobo
Sun Gear
Magnet
Retaining Ring
Alignment Mark
Sun Gear
Gobo
Magnet
DETAIL
GOBO POSITIONS
OPEN