PRG Best Boy Wash User Manual - Manual (Page 31)

BEST BOY ® WASH LUMINAIRE USER MANUAL 23
Comm LED Operation
The Comm LED - located on the upper enclosure connector panel - indicates system control status. This can be used
determine if the luminaire is receiving a control signal. LED indications are as follows:
Figure 2-13: Comm LED
+ Green - The Comm LED will light green if there is incoming communication.
+ Red - The Comm LED will light red if there is no incoming communication.
+ Blinking - The Comm LED will blink (either red or green) if an error is detected.
Bypassing Calibration
If the menu screen is touched (in the center) and held during startup, the luminaire will present a menu that provides
the option to bypass calibration. This feature allows the luminaire to skip the calibration sequence so that it can be
powered up in the case for configuration purposes.
To bypass calibration:
Step 1. Connect power to luminaire.
Step 2. At startup, touch center of menu screen and hold until Bypass
Calibration menu appears.
Step 3. Press Yes to bypass calibration. (The menu will automatically
dismiss if no selection is made within 5 seconds.)
Step 4. Proceed with programming of starting address or other
options.
200 -240 VAC
12A Max
50 / 60 Hz IN
DMX
THRU
ETHERNET
AC IN
COMM
WAKE
Comm LED